Como Installation Guide
3
The Majestic Shower Company Limited
17 Flitch Industrial Estate, Chelmsford Road, Dunmow, CM6 1XJ
Tel44 (0) 8448 001 500
Fac44 (0) 1279 635 074 [email protected] www.majesticshowers.com
The Underframe is supplied over length to be trimmed to size on site.
You can trim up to a maximum of 15 mm from each end of the Underframe. So that the
wall profiles will be similar width on either side of the door, you would ideally trim an equal
amount from both ends of the underframe. However, it is essential to first check the
verticality of the walls. If a wall leans inwards, trim less from that end of the underframe.
If it leans outwards trim relatively more. Cut the underframe with a junior hacksaw and file
the cut ends smooth.
Do NOT cut the Underframe Cover to be used under the Door - this is supplied at the
correct length for your door.
Apply a generous amount of silicone to the recesses on the underside of the
Underframe and place it in position on the shower base. Hold it in position with
masking tape until the silicone has set.
Apply a fillet of silicone at each end of the Underframe to seal it against the walls.
Underframe
Cover -
Door side
< 15 mm
1
