38
360 DVS Series Direct Vent Fireplaces
10006326
Wiring Instructions
The fireplace, when installed, must be
electrically connected and grounded in
accordance with local codes, or in the
absence of local codes, with the current
CSA C22.1 Canadian Electric Code. For
USA installations, follow local codes and
the National Electrical Code
ANSI/ NFPA No. 70.
Any electrical rewiring of this fan must
be done by a licensed electrician.
Should this fan require servicing or
repair, the power supply must be discon-
nected. For rewiring of any replacement
parts, refer to Figure 51.
Method A (Not using EB-1; Fig. 51)
1. Connect the ground wire to the power supply line to
ground stud located on the base of the firebox.
2. Connect the black wire of the supply line to either
terminal of the speed control unit.
3. The second terminal of the speed control unit is
attached to either terminal of the thermal sensor.
4. The second terminal of the thermal sensor is con-
nected to either terminal of the fan motor.
5. The second fan motor terminal is connected to the
white wire of the supply line.
C
B
A
Black
White
Ground
A: Speed Control
B: Temperature Sensor
C: Fan
CFM105
Fig. 51 Method ‘A’ fan wiring diagram.
Remote Controls
Optional remote control units are available to control
different functions of the appliance.
Model
Function(s) Controlled
MRC1
ON/OFF
MRC2
ON/OFF & Temperature
MRC3
ON/OFF & Temperature control with a
digital display and a programmable
24-hour clock
IMT
Wall-mounted thermostat control
Decorative Trim Frame Kit
The DV360TKMP Medium Trim Kit in polished brass is
available for the 360DVS2 model only.
Each kit contains 4 polished brass trim pieces and the
necessary attaching screws to frame one side window of
the unit.
Installation (Refer to Fig. 52)
1. Remove the top louvre assembly.
2. Lower the bottom louvre assembly to expose the
louvre hinges. Unscrew the retaining screws and
remove the louvre assembly from the hinges.
3. Remove the retaining screws that secure the top
deflector plate (above the top louvre opening), and
remove the plate.
4. Using the screws provided, attach the lower trim piece
to the predrilled holes in the lower edge of the bottom
louvre opening.
5. Using the screws provided, attach the two side trim
pieces to the predrilled holes in the vertical side
frames.
6. Use the top deflector plate and the screws removed in
step 3 to clamp the top trim piece in place. With the
trim piece in place along the top edge, refit and secure
the top deflector plate.
7. Reattach the lower louvre panel to the hinges and
replace the top louvre assembly.
All protective plastic wrap must be removed
from the trim pieces before the appliance is
put into service. If plastic wrap is not
removed, a health or fire hazard may
develop.
Method B
For instruction on wiring the EB-1 Electrical Junction
Box, see section EB-1 Electrical Junction Box Connec-
tion on Page 10.
Fig. 52 Decorative trim frame installation.
Trim - bottom
Trim - top
Trim Window Top/Bottom
S
c
r
e
w
s
S
c
r
e
w
s
Screws
Screws
Top trim piece
Top deflector plate
Trim-left
Trim-right
FP1449
