Majestic 33BDVT, Installation Instructions And Homeowner'S Manual

Page: 21 / 38

21
BDVT Series Direct Vent GaS Fireplace
10003358
Unpack the logs from packaging and remove each log
from its wrapping materials.
The logs are fragile and should be
handled with care. Keep the packaging
material out of the reach of children and
dispose of the material in a safe manner.
The individual logs can be identified by numbers
cast on the underside of each log.
Installation of Logs, Lava Rock & Ember Material
33BDVT
Refer to Figure 36.
1. Remove the top louvre assembly.
2. Remove the window frame assembly.
3. Fit the rear front right log (BA8) onto the rear log
support. Ensure the right rear end of the log is
located against the bracket bending up on the right
side of the support.
4. Fit the rear left log (BA7) onto the rear log support.
Ensure the rear right end of the log is located
against the bracket bending up on the right side of
the support.
5. Place the front right log (BA9) in position by resting
the hole under the center of this log located over the
knob on the branch of the rear front right log, and
the front end of this log will also set against the
back wall of the deflector. (Fig. 36)
6. Scatter the ember material over the front area of the
burner housing assembly. (Fig. 36) Do not pack this
material tightly, separate it when unpacked and
keep it in a loose condition.
7. Scatter the lava rock material around the firebox
base.
Do not place any of the lava rock material
on the burner housing assembly.
36BDVT
Refer to Figure 37.
1. Remove the top louvre assembly.
2. Remove the window frame assembly.
3. Fit the rear log (BB13) onto the rear log support.
Ensure the log’s bottom holes are located on the
two pins of the support.
4. Fit the front left log (BB11) onto the left cut out of
the rear log while the front of this log will set against
the back wall of the front deflector.
5. Place the front right log (BB12) in position by resting
the hole under the center of this log located over the
knob on the center rear log, and the front end of
this log will also set against the back wall of the
deflector.
6. Scatter the ember material over the front area of the
burner housing assembly. (Fig. 37) Do not pack this
material tightly, separate it when unpacked and
keep it in a loose condition.
7. Scatter the lava rock material around the firebox
base.
Do not place any of the lava rock
material on the burner housing
assembly.
BA7
BA8
Embers
BA9 LG268
Fig. 36 33BDVT log placement.
33BDVT
36BDVT
BB13
BB11
Embers
BB12
LG267
Fig. 37 36BDVT log placement.
Log Identification Chart
Location 33BDVT 36BDVT 39BDVT 43BDVT
Front Left -- BB11 BC11 BD12
Front Right BA9 BB12 -- BD14
Rear -- BB13 -- BD11
Top Right -- -- BC12 --
Rear Left BA7 -- BC10 --
Rear Fr Rt BA8 -- BC13 --
Top Center -- -- -- BD13