MANUAL OFFSET ADJUSTMENT
(RBMLDG/RBRMDG
) :
1/
Stop the engin, shift the transmission
apply the handbrake and remove the key
2/ Remove the indexing axle and the pin
3/ Pull up the lever (B), and push or pull the machine
laterally to obtain the desired offset (4 positions, 5 /
15 / 25 / 35cm).
4/ Make sure that the lever (B) is fully engaged
replace the indexing axle and the pin (
HYDRAULIC OFFSET ADJUSTMENT
(DGH30) :
o
Adjust the excess flow valve to obtain
a moderate offset speed
is too hight can lead to deterioration
of the mechanism.
Unfasten the locknut «
E »
, Screw the lock
direction «
B »
to increase the flow or un
locking ring in direction «
A »
to reduce the flow
•
USE :
WARNING
Always wear close-fitting clothing to avoid to be snatched by the moving parts. Use safety footwear and
protective equipment for eyes, ears
Do not start the machine when lifted.
connecting power grip with the motor idling.
speed until the nominal speed indi
• Speed
The recommended working speed is between 5 and 10 km/h. It depends on the height and the nature of the
cutted grass.
DANGER
Be careful about the abnormal vibrations o
rotor is equiped with knives after montage
of the rotor and cause vibrations, a quick
Stop the engin immediately.
MANUAL OFFSET ADJUSTMENT
transmission to neutral,
nd remove the key.
and the pin (A).
and push or pull the machine
(4 positions, 5 /
) is fully engaged, and
e the indexing axle and the pin (A).
HYDRAULIC OFFSET ADJUSTMENT
the excess flow valve to obtain
a moderate offset speed. A speed that
is too hight can lead to deterioration
Screw the locking ring
to increase the flow or unscrew the
to reduce the flow.
fitting clothing to avoid to be snatched by the moving parts. Use safety footwear and
and protection from the dust.
Do not start the machine when lifted. Lower on the ground and lift a few centimeters before
connecting power grip with the motor idling. Lower the machine in work position. Increase the engine
e nominal speed indicated on the dashboard of the tractor.
The recommended working speed is between 5 and 10 km/h. It depends on the height and the nature of the
vibrations or noise during use. The rotation speed is very high and
es after montage. Any deteriotation or loss of knives will lead to an imbalance
a quick deterioration of the machine and danger to people.
fitting clothing to avoid to be snatched by the moving parts. Use safety footwear and
Lower on the ground and lift a few centimeters before
machine in work position. Increase the engine
The recommended working speed is between 5 and 10 km/h. It depends on the height and the nature of the
The rotation speed is very high and each
es will lead to an imbalance
of the machine and danger to people.
Summary of Contents for RBML100
Page 11: ......
Page 21: ......
Page 22: ......
Page 28: ...1 Route de Montr al CS30074 11890 CARCASSONNE Cedex 9 FRANCE...