MAITEC ARMATUREN 7008470M, User And Service Manual, Page: 59 / 89

57
5.2.6 Parameter checking
Select and press to enter, press and to check d0-d11 value.
Code Condition Scope Remark
d0 IPM mould temperature 0-120 ℃ Real testing value
d1 Inlet water temp. -9
℃
～
99
℃
Real testing value
d2 Outlet water temp. -9 ℃
～
99 ℃ Real testing value
d3 Ambient temp. -30 ℃
～
70 ℃ flash if Real value<-9
d4 Frequency limitation code 0,1,2,4,8,16 Real testing value
d5 Piping temp. -30 ℃
～
70 ℃ flash if Real value<-9
d6 Gas exhaust temperature 0 ℃
～
C5 ℃ (125 ℃ ) Real testing value
d7 Step of EEV
0
～
99
N*5
d8 Compressor running frequency
0
～
99Hz
Real testing value
d9 Compressor current 0
～
30A Real testing value
d10 Current fan speed 0-1200 (rpm) Real testing value
d11 Error code for last time All error code
Remark: d4: Frequency limitation code,
0: No frequency limit; 1: Coil pipe temperature limit;
2: Overheating or overcooling frequency limit; 4: Drive Current frequency limit;
8: Drive voltage frequency limit; 16:Drive high temperature frequency limit
5.2.7 Parameter setting
Select and press to enter, press and to choose P0-P18 value and press to set.
Note: Long press for 15s to set P14, P18.
Code Name Scope Default Remark
P0 Mandatory defrosting 0-1 0
0: Default normal operation
1: mandatory defrosting.
P3 Water pump 0-1 0
1:Always running;
0:Depends on the running of compressor
P7 Water temp. calibration -9
～
9 0 Default setting: 0
P14 Restore to factory settings 0-1 0
1-Restore to factory settings
，
0- default
（
restore P0
、
P3
、
P7
、
P8
、
P9
、
P10
、
P11 to factory setting)
P16 Product code / / Depend on the machine
P18 Mode 0-1 0 1—Heating only
，
0—Heating/Cooling/Auto mode