Operation Manual easyTymp
8111254 Rev. 7.0
18
02/16
4.3.1.7 Charging the Battery
Figure 13
NOTE:
Please note that the battery needs to be charged for a
minimum period of approximately 6 hours prior to first use of the
easyTymp hand-held Tympanometer (Figure 13). To charge the
battery please place the easyTymp into the cradle and connect
the cradle to the mains power with the use of the easyTymp
power supply provided.
Figure 14
The spare battery is stored and charged in the back of the cradle
(Figure 14). Battery LED will show solid blue when the spare battery
in the cradle is fully charged. The LED will flash as long as the
battery is charging.
Please observe the following precautions:
-
Keep the battery fully charged.
-
Do not place the battery in fire or apply heat to the battery.
-
Do not damage the battery or use a damaged battery.
-
Do not expose the battery to water.
-
Do not short circuit the battery or reverse the polarity.
-
Use only the charger provided with the easyTymp
-
Please see the following section for estimated charging times.
4.3.1.8 Battery Life
The following table gives an estimate of the charging time (CT) in hours for the battery.
Be aware that negative numbers mean that the battery is discharging. Charge times are
the same for the spare battery in the cradle and the battery in the cradled easyTymp.
CT
through
cradle up to 80
%
CT
through
USB (PC) up
to 80 %
CT
through
cradle up to 100
%
CT through USB
(PC) up to 80 %
Off
1.5
3.8
2.3
5.7
On (pump off) 2.8
-32
4.1
-47
Summary of Contents for easyTymp
Page 1: ...Operation Manual easyTympTM...
Page 2: ......
