Mahr umaxum II, Instruction Manual, Page: 38 / 72

38
6.4.1 Analog Bargraph Operation [S]
The center bargraph line blinks when tolerance value(s) have been entered in the setup
mode. If the center line is solid (not blinking) then there is no tolerance value(s) entered
into the indicator and tolerance indication is disabled.
The left and right arrows of the bargraph are used to indicate the tolerance condition as
shown here:
Figure 29 -
Analog Bargraph
6.4.2 Digital GO/NOGO operation [S]
GO/NOGO operation requires that tolerance values have been setup in the indicator. The
inch/mm button is used to sequence through four display choices:
Figure 30 -
Digital GO/NOGO Operation
OOT Low Indication OOT High Indication
N u m e ric d isp la y (in ch )
G O /N O G O d isp la y (in ch )
N u m e ric d isp la y (m m )
G O /N O G O d isp la y (m m )