Mahlkonig X54, Original Instructions Manual

Page: 25 / 60

25
Home Grinder X54
Inserting the bean hopper
1. Pull the sliding valve (3) all the way out
of its guide on the bean hopper (1)
(see Fig. C ).
The bean hopper can only be inserted when the
sliding valve is in position 1 (= pulled out to the
maximum).
2. Place the bean hopper on the bean hopper intake (4)
(see Fig. F ).
When placing the bean hopper on the bean hopper
intake, it must be aligned in such a way that the nose
on the lower edge of the bean hopper slides into the
corresponding recess in the bean hopper intake.
3. Press the bean hopper down into the bean hopper
intake and push the sliding valve in up to the marking
(see Fig. D ).
The sliding valve engages perceptibly in place in
position 2 and locks the bean hopper in the correct
position in the bean hopper intake.
If the bean hopper cannot be inserted or the
sliding valve does not lock the bean hopper, the
bean hopper was probably not correctly aligned
when it was inserted or the sliding valve was
not in position 1 (=pulled out to the maximum)
when the bean hopper was inserted.
»
In this case, repeat Step 1 and Step 2 and
then press down and push in the sliding
valve to lock the bean hopper.