Compliance Information
FCC Information
This device complies with Part 15 of the FCC Rules.
Caution:
Any changes or modifications not expressly approved could void the user's authority to operate the
equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radiation Exposure Information
This device has been evaluated to meet general RF exposure requirements. The device can be used in portable
exposure conditions without restriction.
Rating Label Definitions
The ETL Mark is proof of product compliance to North American safety
standards. Authorities Having Jurisdiction (AHJs) and code officials across
the US and Canada accept the ETL Listed Mark as proof of product
compliance to published industry standards.
CM
US
C
LISTED
Intertek
3162944
Cleaning
Using a soft, damp cloth, wipe the bowl of the cover
clean. Do not use any sort of soaps or detergents as
this can damage the lamp.
If there is any wax stuck to the bowl, carefully
dislodge it.
Turning the lamp on to warm any existing wax may
make it easier to remove.
Replacing the Lightbulb
A 25W incandescent lightbulb comes installed with this product.
If it breaks or burns out, turn off the lamp, unplug the cord, and
let the bulb cool for 15-20 minutes before handling.
Carefully unscrew the lightbulb and replace with a new 25W
incandescent bulb.
NOTE: To properly heat the cover of the lamp you MUST use a 25W
incandescent bulb.
