en
|
8
|
CAD-FL & CAD-FL3
Channel
Frequency
Confirm
Frequency
Channel
100
Please select and confirm the
desired radio settings for this
lift.
1
2
1
Current Location:
Enter the Lift's
position by touching
the corresponding
location button.
7. Operation
7.1 Installation Instructions
The adapter components are heavy and will require two
people to handle. If using a lift system that has a different
operating system than referred to in this manual, consult
the manual supplied with the lift system for information on
setting up and operating the lifts.
1.
Make sure the master on/off switch on each lift
unit is set to the OFF position. Turn the master
on/off switch on the first lift unit to the ON position
(see the lift system owner’s manual for location of
the master on/off switch). The Home screen will be
shown with a series of icons on the screen. Select
the Lift Program icon to start the program used to
lift a vehicle. After initialization of the Touch
Screen, the below screen will be displayed.
2.
Select the desired radio settings. The default radio
settings will be the settings selected the last time
the unit was used. Push the up and down arrows
on the right side of the screen to change the radio
frequency and/or channel, if needed. All units that
will be used together as a lift system to lift a vehicle
must be set to the same frequency and channel.
When the desired radio settings are shown, push
the Confirm button to advance to the next screen.
3.
Read through the Notice that is displayed on the
next screen. If the operator agrees with and
acknowledges the statements made on the screen
push the Accept button to continue setting up the
lift system.
4.
The display then changes to ask how many lift
units are going to be part of the lift system. Push
the 2 button to set the lifts up as a set of two.
5.
On the following screen, choose Forklift Adapter
Mode in order to raise the set of two lifts full height.
WARNING! Only use Forklift Adapter Mode with a
manufacturer supplied forklift adapter.
6.
The display will now appear as shown below with
a picture of a vehicle asking for the current lift
unit’s position relative to the vehicle. Select the
round button with a number inside it that matches
the current lift unit’s position. Once the position is
selected the position button will turn green to
indicate the selection.
7.
Now move to the second lift unit and turn the
master on/off switch to the
ON position. The
same screen shown in Step (1) above will
appear.
Select
the same radio frequency and channel as was
chosen in Step (2) above by pushing the up and down
arrows on the right side of the screen. When the correct
radio settings are shown, push the Confirm button.
8.
The display will now show the same screen as
shown in Step (6) above. Select the round
button that matches the position of the current
lift unit relative to the vehicle. The position that
has already been selected will be shown by a
yellow colored button.
9.
Once both units are initialized (radio settings
and position relative to the vehicle selected)
the lifts will be ready to operate.
10.
Raise the Lift Carriages about 10 inches and install
the Lift Platforms as shown in the figure below.
Ensure the guide pin is fully inserted into the
correct hole on each lift arm. The lift arms must be
adjusted such that they are the correct width to
properly accept the forklift adapter.
