108
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document, are
prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd., will
amount to unauthorized use and shall be liable for penalty/prosecution© 2021 Mahindra & Mahindra Ltd.
• Measure the resistance between pin
14
and pin
6
of the DLC connector
(C 555)
ACCEPTANCE CRITERIA
• Resistance = 60±10 Ω
ACTION TO BE TAKEN
OK
NOT OK
•
GO TO STEP 6
• Suspect internal short in immobilizer
• Replace the immobilizer with a new one
• Check and confirm that ECUs are able to
communicate with i-SMART
• Clear the DTC and verify
STEP 6— CHECK CAN HIGH & LOW WIRES FOR SHORT CIRCUIT TO GROUND
PRE CONDITION
• Ignition OFF
• Battery negative and positive terminals DISCONNECTED
• All ECUs and terminating resistor connected with CAN
TEST PROCEDURE
• Measure the resistance between pin
14
of DLC connector
(C 555)
and disconnected
battery negative terminal
• Measure the resistance between pin
6
of DLC connector
(C 555)
and disconnected battery
negative terminal
ACCEPTANCE CRITERIA
• Resistance = ∞ Ω
ACTION TO BE TAKEN
Diagnostic Manual
XUV700 (Diesel)
UICU
MAN-01065
OCT - 2021/Rev 1
Summary of Contents for XUV700 2021
Page 2: ......
