MAHINDRA APPLITRAC
draft on the implement constant and is useful while using it on leveled field
with constant soil texture. Please refer tractor Operator manual for using the
position and draft control levers.
Do not transport or attach equipment when the hydraulic system is in Draft
control. Always lower the implement to ground level before stopping the
tractor. Do not use Draft control lever to lift implement to its uppermost
position.
Adjustments for MB Plough
Adjusting the Width of Cut
This adjustment should be used for
increasing or decreasing the width of
cut. If the tractor is working under
high load condition, decrease the
width of cut.
1.
Loosen the bolt (A) and four bolts
of Bolt (2 on either side B).
2.
Rotate the hinge bar (C), so that
the bolt A should fix to the next
screw seat on the shaft.
3.
For decreasing the width of cut
(by 25 cm) the plow rotate the
hinge bar / shaft (C) in clock wise
direction as shown above.
4.
For increasing the width of cut
(by 25 cm) the plow rotate the
hinge bar / shaft (C) in counter
clock wise direction.