25
BA491701-en
Pos: 123 /Technische Dokumentation/Alle Geräte/Überschriften/Überschriften 1.1/D/Überschrift 1.1: Display-Codes @ 20\mod_1270028830605_75.docx @ 832653 @ 2 @ 1
5.6
Display Codes
Pos: 124 /Technische Dokumentation/Hebetechnik/49 Radgreifer-Hebebühnen/1701 RGE UNI TRAM/BA/Inhalt: 4917 Display-Codes @ 36\mod_1393923865854_75.docx @ 1914619 @ @ 1
Display Code
LED
Cause
Action
Green
Normal operation, no errors.
Normal operation.
Yellow on
1 or
several
column(s)
Uncontrolled operation.
Bus line failure.
Replace connecting cable.
CAN bus without terminating resistor.
Check terminating resistors of CAN bus
in dummy plug and power supply unit,
contact service.
CAN controller out of step or defective.
Turn the main switch off and on again.
If error persists, contact service.
Controller in sleep mode due to short-
circuit of CAN lines.
Replace connecting cable. Contact
service if necessary.
Yellow on
1 column,
Green on
all others
Safety switch triggered.
Carriage has made contact with
obstacle.
Switch column with error message to
single mode. Raise carriage to unlock
the safety wedge or remove obstacle.
Red on
1 column
Thermoswitch triggered.
Overheated motor. Lift stops and error
message appears.
Let the motor cool down. Check
thermoswitch, motor and column.
Acknowledge error with selector button
on control panel.
Red LED will go out and the lift is ready
for operation.
Yellow on
all
columns
Insufficient speed / Overspeed.
Lift stops when irregular motor speed is
detected.
Release control element. The error is
removed and the lift is ready for
operation.
Red on all
columns
Overloaded lift.
Maximum permissible load exceeded.
Lower lift to bottom position.
Acknowledge error with selector button
on control panel.
Red on all
columns
Proximity switch defective.
Proximity switch defective due to short-
circuit or broken wire.
Proximity switch must be replaced,
contact service. Acknowledge error
with selector button on control panel.
