24
BA551501-en
5.2
Checking the Safety Device
WARNING
The safety device must be checked by operating the lowering spindle (A):
1 Turn the lowering spindle counterclockwise.
2 Release the lowering spindle, it must return to its initial position.
3 In addition, check the torsion spring for corrosion and damage.
5.3
General Operating Instructions for Lifting Accessories
WARNING
•
Support tubes must not be extended. Risk of tilting!
•
Danger of crushing at the edge of the pit and support bridge!
•
The support system shall only be removed if the vehicle is in a secure stable
position.
•
Beware of changes in the centre of gravity of the load, e.g. in case of differ-
ent amounts of fuel in asymmetric fuel systems. If necessary, use suitable
lifting accessories.
•
Take note of the operating instructions of all equipment and tools used.
•
Check lifting accessories carefully for operational safety.
•
Pre-position the lift and lifting accessory at the lift points.
•
Always take up the load securely, without risk of slipping and central to the
centre of gravity.
•
Position actuators, supports and bases at the support points and depending
on type, fix support pipes with pins and secure with cotter pins or wooden
blocks with a minimum spacing of 500 mm.
•
Slowly raise or lower the load, watching it continuously.
•
Set down the load without risk of slipping and central to the centre of gravity.
