3 - XY Transport Ribbon Cable Replacement Procedure
ExpressCard 2000| Instant Issuance Card Personalization System | XY Transport Ribbon Cable Replacement Procedure
Page 8
3.2
Remove / Re-install the XY Transport Ribbon Cable
This section provides information for replacing just the XY transport ribbon cable, which occasionally
must be replaced without replacing the entire module. For instructions on removing and re-installing the
entire XY transport module, see
99875607 ExpressCard 2000 Hardware Service Manual
or
33070932
ExpressCard 2000 XY Transport Module Replacement Procedure
.
Figure 3-1 - XY Transport Showing Ribbon Cable (FRONT VIEW)
To remove the XY transport module’s ribbon cable, follow these steps:
1)
Open the top access door (see
99875607 ExpressCard 2000 Hardware Service Manual
).
2)
Move the XY transport to the front of the device to expose its cable and its connection to the circuit
board (“breakout board”) on the base plate of the device (see
99875607
ExpressCard 2000 Hardware Service Manual
for details).
