Magnum MIG 208 Alu Synergy, Operating Manual

Page: 20 / 24

90% He + 7.5% Ar +
2.5% CO
2
e + 35% Ar + 5%
WHAT
2
weakly oxidizing Corrosion-resistant steels, short-arc welding
60% of H.
High toughness low alloy steels, short arc
welding
oxidizing
8.
CLEANING AND MAINTENANCE
The protection class of this device is IP21S, so do not use the device in the rain or
expose it to moisture.
CAUTION:
Device based on electronic components. Grinding and cutting
metals near the welding machine can contaminate the inside of the
device with filings, thus damaging it.
The above-mentioned damage is not subject to warranty repair!
If you need to work in such an environment, clean the device by
blowing the inside of the welder with compressed air.
In order to extend the service life and reliable operation of the device, several rules must be followed:
1. The device should be placed in a well-ventilated room with free air circulation.
2. Do not place the device on wet ground.
3. Use wire of the diameter and weight of the spool in accordance with the table.
4. Place the shielding gas cylinder on the shelf at the back of the semi-automatic machine and
secure it against the possibility of tipping over with a chain.
5. Check the technical condition of the device and welding cables.
6. Remove any flammable materials from the welding area.
7. Use appropriate protective clothing for welding: gloves, apron, work shoes, mask
or visor.
When planning the maintenance of the device, the intensity and conditions of use should be taken into
account. Correct use of the device and regular maintenance will help to avoid unnecessary disturbances
and breaks in work.
Every day:
ABOUTClean the mass handle and gas nozzle from spatter, lubricate with anti-
spatter agents.
ABOUTCheck that the cables are securely connected.
ABOUTCheck the condition of the wires. Replace damaged cables.
ABOUTMake sure that there is free air flow around the device.
ABOUTReplace or repair damaged or worn parts.
twenty