Magnum MI-81350, Operating Manual

Page: 14 / 28

13
Cutterhead Removal
If removal of the cutterhead is necessary, do the
following:
WARNING: Disconnect jointer from
power source.
Step1. Loosen 8 screws (B) on the rear cover
by 4mm Hex. Wrench , take off the rear cover.
Step 2. Loosen 2 screws (I) on the front cover.
Step 3. Loosen 4 CAP screws (J) on the base
frame by 5mm Hex. Wrench, remove the front
cover (K)
Step 4. The pulley cover (O) is mounted by 4
Round Head phillips screw w/teeth washers (P)
to the threaded holes in the Stand, Fig. 10.
Step 5. Remove the V-belt (J) from cutterhead
pulley and motor pulley.
Step. 6 Loosen CAP screw (L) on the rabbet
arm by 6mm Hex. Wrench, remove the blade
guard (M)
Step 7. Loosen 2 Round Head Phillip Screw
w/Washers (E) then remove cutterhead cover
(F)
Step 8. Loosen 2 CAP Screws(C). Flat
Washers then remove rabbetting arm from
Infeed Table.
E
C
D
O
P
M
L
J
K
J
I
B
F
！