- 12 -
M
AGNUM
-OP-EN
MACHINE SETUP
UN-CRATING MACHINE:
Carefully check the crate for any signs of damage and that
the batteries are in the unit.
To un-crate the machine, remove banding strips from
around the crate. Take off the top and sides and dispose
properly. Remove brackets from machine wheels.
Remove bolts from pallet, then remove board. Carefully
roll the machine off of the base. Notify the carrier
immediately if concealed damage is discovered.
CONNECTING BATTERIES:
9OURMACHINEISEQUIPPEDWITH
×
6OLT!(
×
)
6OLT!(
×
6OLT!(OR
×
6OLT!(
7ET,EAD!CID!'-OR$EEP#YCLE"ATTERIESWHICHFORM
a 24 Volt system.
(SEE PICTURE BELOW OR BATTERY DISCONNECT
LABEL FOR CORRECT CABLE CONNECTIONS)
1.
Turn all switches to the
OFF
POSITIONANEY
F
(if machine is equipped with Optional Key Switch)
.
2.
!TTACHALL"ATTERY#ABLESTO4ERMINALSASSHOWNBELOW
3.
Turn
ON
main power switch and check the battery
N
condition meter to ensure correct installation. Charge
Batteries if needed
(SEE BATTERY CHARGING)
.
NOTICE
Batteries are a possible environmental hazard. Consult
your Battery supplier for safe disposal methods.
NOTICE
Orientation of Batteries is critical for cables to reach.
ATTACHING SQUEEGEE:
1.
Lower the Squeegee Mounting Plate by rotating the
Squeegee Lift Lever
(A)
in a clockwise motion
)
(SEE
BELOW)
.
2.
Loosen the two knobs
(B)
on the Squeegee and slide
)
them into the slots in the Squeegee Mounting Plate
(SEE BELOW)
.
3.
4IGHTENTHETWOKNOBSANDCONNECTTHE6ACUUM(OSE
(C)
from the machine to the Squeegee
)
(SEE BELOW)
.
4.
9OUMAYHAVETOADJUSTTHE3QUEEGEE0ITCH
(SEE
ADJUSTING SQUEEGEE ON THE NEXT PAGE)
6V
6V
6V
6V
24 VOLTS
A
B
B
C
Summary of Contents for 28'' DISK
Page 42: ......
