Vise Adjustment
To position the moveable vise jaw:
1.
Turn vise handwheel (A
– Fig.10) 1/2 turn
counter-clockwise.
2.
Move rack block (B
– Fig.10) to desired location
by sliding along the bed. Place the rack block
onto the rack.
3.
Turn the handwheel to tighten the vise.
To adjust the vise for angle cutting:
1.
Loosen bolts and move vise jaw (C
– Fig.10) to
desired location.
2.
Set the vise to desired angle, reinstall nuts and
tighten the nut and bolt assemblies.
3.
Make sure the movable vise jaw parallels to the
fixed vise jaw. Loosen the bolt (D
– Fig.10) and
adjust it until it is in parallel with the fixed vise jaw
and tighten the bolt.
Setting Up the Machine for Operation
1.
Select the proper speed and blade for the type of
material you are going to cut.
2.
Make sure blade tension is adjusted properly.
3.
Lift the saw frame up and turn off the oil regulating
micro switch.
4.
Place the stock between the vise jaws, set the
stock for the desired length of cut and tighten the
vise.
5.
Make sure the left blade guide bracket (A) is
adjusted as close as possible to the left vise jaw
(B) Fig.11.
6.
Turn the oil regulating micro switch (C) Fig.11,
counter-clockwise until the saw blade begins to
lower by the desired rate.
7.
Proceed to cut through the workpiece, as shown
in Fig.11. The machine will shut off upon
completion of cut.
12
