5
Assembling Motor Access Door
• See Figures 1 and 2.
• Tools: 17 mm wrench
The saw is shipped with a bracket (A) that secures the motor
during transportation.
1. Using a 17 mm wrench, remove the shipping bracket (A)
2. Remove the remaining hex cap screws, lock washers and
flat washers (B) in the table edge.
3. Install motor access door (C) by aligning the pins on the
door with the brackets (D) on the cabinet.
4. To secure the access door, pull the latch (E), close the door
and release the latch.
Installing the Side Handwheel
The front handwheel is pre-installed at the factory. The side
handwheel and lock knob, however, must be installed after
unpacking the saw.
1. Align the keyway on the handwheel with the keyway on
the shaft; then install the handwheel onto the shaft.
2. Tighten the set screw to secure the handwheel
3. Install the lock knob by carefully threading it into the
shaft, turning it in a clockwise direction.
Fence Storage Hooks
• Tools: 5 mm hex wrench
Two hooks are included for mounting the rip fence when it's
not in use.
1. Mount the hooks to the cabinet with 1/4" x 5/8" socket
head cap screws, lock washers and flat washers.
ASSEMBLING THE SAW
MAGNUM INDUSTRIAL MI-51180 TABLE SAW
FIGURE 1: MOTOR SHIPPING BRACKET
WARNING
Do not connect the saw to a power source until it has been fully assembled.
FIGURE 2: MOTOR ACCESS DOOR
