14
Changing the Belt
• See Figure 21
• Tools: 17 mm wrench
Inspect the drive belt on a regular basis. When the V-belt
begins to show signs of wear, such as fraying or cracking, or if
it slips under load, replace the belt.
1. Turn the power switch to Off and unplug the machine from
the power source.
2. Lower the blade to its lowest point.
3. Loosen the two hex cap bolts (A) on the motor bracket.
4. Take the tension off the V-belt (B) by lifting the motor.
5. Remove the belt from the arbor and motor pulleys.
6. Install the new belt. The weight of the motor should apply
enough tension to the belt so it doesn't slip. Tighten the
hex cap bolts (A).
7. After you've used the saw for a few hours, check the belt
tension and adjust if necessary.
WARNING
Always turn OFF the power switch and unplug the machine before making any adjustments.
MAINTAINING THE SAW
MAGNUM INDUSTRIAL MI-51180 TABLE SAW
FIGURE 21: CHANGING THE BELT