2
© 2011 Magnum Energy, Inc.
1.0 Introduction
1.2 Compatibility and Measurement Channels
Info:
All operational information and measurements are
provided by the connected equipment. The MagWeb system
collects and transmits this information. The MagWeb device
is compatible with RD/ME/MS/MS-PAE inverters (versions
2.6 and greater), and MM/MMS inverters (1.0 and greater).
Availability, accuracy, and resolution of the measurements are
dependent on the particular model(s) of Magnum equipment
connected. Contact Magnum Energy to determine if a particu-
lar measurement on your inverter or accessories is compatible
with the MagWeb system. Some settings and measurements
are done inside the remote control. Because of this, the data
is not transmitted externally from the remote control and the
MagWeb will not be able to monitor or display this information.
1.2.1 Inverter Only
Not all inverter models provide all measurement channels.
• Inverter model and revision
• AC amps in and out
• Inverter stack mode
• AC frequency
• Status, including fault(s)
• Invert and Charge LEDs
• DC volts
• Battery temperature
• DC amps
• Transformer temperature
• AC volts out
• FET temperature
1.2.2 In Remote
Compatible with all versions of Magnum’s Standard Remote Control
(ME-RC50), Advanced Remote Control (ME-ARC50), and Router (ME-RTR).
For PAE systems using the Magnum router, the current MagWeb fi rmware will
only monitor one inverter and one of each type of accessory.
Monitored data includes all standard inverter channels plus:
• Remote revision
• Low voltage (AC and DC) cutout
• Inverter search watts
• Battery type and custom absorb,
fl oat, and equalize voltages
• Battery size and type
• Absorb done time
• Charge rate and AC input amps
1.2.3 In BMK
All inverter and remote channels and:
• Battery Monitor revision
• DC volts – minimum & maximum
• BMK status including fault(s)
• Battery effi ciency settings
• State of charge
• Amp hours in and out
• DC volts
• Resettable and total amp hours
• DC amps
1.2.4 In BMK + AGS
All inverter and remote and BMK channels and:
• AGS status including fault(s)
• Gen runtime
• AGS temperature
• AGS revision
• AGS voltage
• AGS start/stop settings
