7
The Viewing Table (sometimes referred to an X-Y Table) is mounted on
a slide mechanism allowing it to move under the camera left to right
and also front to back. This assists you in moving the material you are
viewing under the camera.
Using the Viewing Table
magnification, the angle of lighting from one set or the other may
improve the HD image. The factory setting is the with the REAR lights
ON. In most cases, this is optimal for most material.
To change the lighting, locate the LIGHT Switch under the front, left
corner of the Camera unit. Changing the switch position will change
turn ON the front or rear lights. Once the preferred setting is
determined, the lighting can normally be left in that setting.
Switching the Lighting (cont’d)
Brake
(To Lock)
Moving the lever all the way to the RIGHT locks the table
Releasing the back to the CENTER position restores full table
movement front to back and side-to-side
Depending on what is being viewed, sometimes users prefer that the
Viewing Table remain steady or locked. The Table is equipped with a
Brake Lever to Lock the movement of the table. The Lever is located
below the front edge of the table as shown.
