On the next screen, enter the actual process media location
and then hit OK.
A password window will then appear (unless the password
was previously entered). Enter the password and hit OK.
Then the system calculates the curve, and then saves it. Hit
OK to confirm.
A warning screen is then shown so that the loop can be
returned to automatic control.
At this point the echo rejection curve can be viewed by
selecting Rejection Curve as Curve 2 in the lower left corner
of the screen. The Rejection curve will then be displayed in
red as shown in the screenshot above.
Alternatively, you can follow the procedure below:
Select the Device Setup tab, and then select the Advanced
Config tab. Then click on New Rejection Curve.
85
BE 57-660 Eclipse Model 700 Guided Wave Radar Transmitter
