![background image](http://html1.mh-extra.com/html/magnetek/telemotive-mltx2/telemotive-mltx2_user-manual_3613915026.webp)
Enrange MLTX2 Intrinsically Safe
Transmitter Instruction Manual
April 2019
Page 26 of 44
To utilize the RCP IR configuration feature on compatible transmitters:
1. Push the OFF-ONSTART toggle to the START position and hold for more than 5 seconds.
a. When the transmitter successfully enters the IR configuration mode, the Power/Status
and Battery LED(s) will blink alternately continuously.
2. After the LEDs are blinking alternately, point the IR adapter at the IR window of the transmitter
and use RCP to send and receive data.
NOTE: This is the same procedure to utilize IR Configuration Pairing with a receiver. The difference is
that to pair a transmitter with a receiver you have to press the OFF-ON START toggle. To communicate
with RCP you do not have to press start (this will place you into a different mode). The device is sitting
ready to communicate while the LEDs are blinking.
4.1.4.2 IR Configuration Receiver on Transmitters Equipped with Single Status/Battery LED
Indicator
To utilize the IR configuration receiver function and link to a compatible receiver, push the OFF-ON-
START toggle to the Start position and hold for more than 5 seconds. When the transmitter successfully
enters the IR configuration mode, the Status/Battery LED will blink continuously. After the LED is
blinking, point the IR window of the transmitter at the desired receiver to control and momentarily press
the OFF-ON-START toggle to the Start position and release.
If the link is successful, the LED will stop blinking and the transmitter will shut down. The new settings
obtained from the IR configuration function will take effect upon the next power cycle of the transmitter.
If the link is unsuccessful with a compatible receiver, the Status/Battery LED will continue to blink.
To cancel the IR configuration receiver without a successful link, move the OFF-ON-START toggle to the
OFF position.
4.2
USING THE TRANSMITTER IN SETUP MODE (WITH OPTIONAL GRAPHIC USER
INTERFACE)
NOTE: The Setup Mode is only accessed on transmitters equipped with the optional graphic user
interface. The units equipped with the standard status LED can only have the settings of the transmitter
changed at the factory.
The Setup Mode can be used to edit configuration settings such as: Access Code, Channel Select, User
Code, Transmitter Time Out, Backlight Time Out, Password Enable, Change Password, and more.
NOTE: No parameter changes will take effect until the user has selected ‘Save and Exit’ from the Setup
Mode.
4.2.1
Entering Setup Mode
To enter the Setup Mode, first make sure the unit is OFF and the Machine Stop switch is raised. Next,
push the OFF-ON-START toggle switch to the START position and hold it in the START position for more
than 5 seconds until the setup screen appears.
The user will see a prompt for a four digit password if the password feature is enabled. If no password is
enabled, then the adjustments in Section 4.2.2 will be available with no further input required from the
user.
NOTE: The password feature is enabled by default from the factory.