![background image](http://html1.mh-extra.com/html/magnetek/mini-mbt-transmitter-engineered/mini-mbt-transmitter-engineered_user-manual_3612842022.webp)
Enrange Mini-MBT Instruction Manual
June 2015
Page 22 of 37
Backlight Timeout can be set from 1 to 30 seconds.
Setting Timeout to disable will disable the backlight.
Setting Timeout to “always on” sets the backlight to be on continuously while the transmitter is on and
active.
NOTE: Leaving the backlight on longer will decrease the battery run time and will require more frequent
battery replacement (or recharges for optional rechargeable battery packs).
4.2.2.7 Set Clock
This sets the system clock for the Mini-MBT unit. The clock is set in the following format:
10/01/12
13:12:11
MM/DD/YY
hh:mm:ss
If ‘
Save and Exit’
is selected from the setup menu after changing this parameter, it will immediately take
effect.
4.2.2.8 Password Enable
This setting enables or disables the requirement of entering a password into the transmitter to enter
Setup Mode.
When the disabled setting is selected the user will go directly into Setup Mode without being prompted to
enter a password.
Magnetek strongly recommends enabling the Setup Mode password setting to prevent unauthorized or
accidental changes to parameters.
NOTE: The unit is shipped with the password requirement enabled and utilizing the factory default
password.
4.2.2.9 Change Password
This allows the user to change the password needed to enter the Setup Mode.
The password must consist of 4 digits.
4.2.2.10
IR Configuration Receiver
IR Cfg Recv function in the setup allows the transmitter to link to a compatible receiver by using IR
(contact the factory to determine if your receiver is compatible) and automatically set up the channel and
access code to match the linked compatible receiver.
Figure 7: Mini-MBT IR Window
After selecting this option, point the IR window located on the bottom of the transmitter (as seen in Figure
7) at the desired receiver to control and momentarily press the OFF-ON-START toggle to the START