Flex M Engineered Receiver Instruction Manual
May 2019
Page 21 of 50
3. The total system current consumption should not exceed the maximum output supply current of
the power supply module. If additional supply current is required, contact the factory for a custom
solution.
4.3.1 POWER SUPPLY LED OPERATION
When the Flex M system has power supplied, the two LEDs on the power supply module should be lit and
solid.
Figure 13. GEN1 Power Supply Module LED Placement
•
+5VDC CPU
o
Indicates that +5VDC power is going to the CPU
•
+5VDC RELAY
o
Indicates that +5VDC power is going to the RELAY modules
4.4 POWER SUPPLY MODULE – GEN 2
This section is applicable to the following power supply module part number(s):
•
198-80104-PSAC00 (90-250VAC 50/60Hz)
•
198-80104-PSDC00 (6-36VDC)
•
198-80104-PSLAC0 (18-56VAC 50/60Hz)
Identifying a GEN2 Power Supply module:
•
The module will contain a label with one of the part numbers listed above
•
The LED overlay decal will be blue
All of the Flex M power supply modules convert their input supply power to a nominal 5VDC output for all
the attached Flex M modules. This power module has a maximum output supply current of 2000mA
(shared between CPU and relay outputs). There is one power supply module in the Flex M system.