Flex I-Chip Remote Crane Controls
August 2010
9 of 28
D. Testing Receiving Module
To check if the receiving module is in good order please follow the instructions below.
1)
Press the Test Mode Select button until the LCD screen displays “Testing Receiver Module 2”.
2)
The LCD screen is displayed as follows:
Testing Receiving Module
S - - - - - -
T - -
M - -
↓
↓
↓
Serial number Type
Mode
3)
Plug the receiving module to be tested on to this unit.
4)
Use a good transmitter handset (any type) to test the receiving module.
5)
Set the channel dip switch on the receiving module to the one set on the transmitter.
6)
Turn the transmitter power on and rotate the power key to the Start position. The SQ2 LED should light
up or blink; if not, then the receiving module is defective.
7)
If SQ2 LED blinks red with all the transmitter information shown on the LCD screen then the decoder
module is defective.
