Flex I-Chip Remote Crane Controls
August 2010
12 of 28
3. Program System Serial Number
Change the system’s serial number simply by moving the black arrow on the LCD screen to the
S/N
location via NEXT and PREVIOUS button, then either press the
↑
&
↓
arrows or the number buttons
directly to change the serial number.
When finished, take the same I-Chip and insert it onto the I-Chip programming port (located on the
decoder module) to transfer the serial number from the I-Chip to the receiver. To transfer I-Chip information
to the receiver, JP6 must be inserted (not required if programmed directly on the decoder module –
Section E).
4. Program System Type
Change the system type simply by moving the black arrow on the LCD screen to the
TYPE
location via NEXT
and PREVIOUS button, then press the
↑
&
↓
arrows to change value. For standard systems, always set the
value at “00”. For tandem transmitters, you must set tandem transmitter-A to “01” value and tandem
transmitter-B to “02” value.
When finished, take the same I-Chip and insert it onto the I-Chip programming port (located on the
decoder module) to transfer the Tandem function to the receiver (transmitter-A to receiver-A and
transmitter-B to receiver-B). To transfer I-Chip information to the receiver, JP6 must be inserted (not
required if programmed directly on the decoder module – Section E).
5. Program Start/Aux Function
(not required if programmed directly on the decoder module - Section E)
After initiating the START function, the same location will then become an AUX function. You can set the
FUNCTION relay in the receiver, when rotate to START position, the relay will close momentarily, toggled or
toggled affected by E-Stop activation. When set with the START/AUX function, the external warning function
is no longer available. Add the START/AUX function simply by moving the black arrow on the LCD screen to
the
AUX
location via NEXT and PREVIOUS button, and then press the
↑
&
↓
arrows to change value.
---
:
START function only, no AUX function thereafter.
NOR
:
START fu AUX with normal momentary contact.
TOG :
START fu AUX with toggled/latching contact.
T/E
:
START fu AUX with toggled/latching contact affected by the E-Stop
button (FUNCTION relay will open when e-stop button is pressed down)
EXT
:
FUNCTION relay works simultaneously with receiver MAIN.
When finished, take the same I-Chip and insert it onto the I-Chip programming port (located on the
