TER Ceska
Flex EX 4, Flex EX 6
Instruction manual
5. Functions settings
5.1. Channel Change via Push Buttons
The transmitter channel can also be changed directly on the push buttons. Please refer to the instructions below on how to
change the transmitter channel via push buttons.
Press E-STOP button first, then press and hold PB1, PB2 and PB3, rotate the power key to „START“ position at
the same time and release E-STOP button. A series of green and red blinks will appear on the Status LED
showing the current channel setting. A green blink represents the tens (+10) and a red blink represents the
units (+1).
Examples:
2 green blinks followed by 5 red blinks represents channel 25, 6 red blinks represents channel 06.
Select a new channel by pressing PB1 and PB2 on the transmitter. Press PB1 to increment the units (+1) and PB2
to increment the tens (+10).
Examples:
Pressing PB2 two times and then PB1 four times will give you channel 24, pressing PB1 nine times
with give you channel 09.
When finished, the newly selected channel will appear on the Status LED via a series of green and red blinks
again.
Exit the channel programming by turning off the transmitter power.
Make sure the receiver channel is set identical to the transmitter:
After changing the transmitter channel turn on the transmitter power, rotate the power key switch to the
„START“ position, and hold it there for up to 1 minute. Within this 1-minute period the receiver will search
(channel 01 – channel 62) and lock onto the newly selected transmitter channel automatically. Please note that
in order for the receiver to switch to auto-scanning mode, you must first deactivate the receiver MAIN by
shutting off the transmitter power or press down the emergency stop button before changing the transmitter
channel.
Please note that when channel is set beyond channel 62 via PB1 and PB2 (i.e. channel 63, 68, 88, etc…), the
Page 10 of 27
December 2015
