Flex 4Base® CE Instruction Manual
January 2017
Page 34 of 41
432 mm
Control
Panel
1. For best reception the location of the receiver should be visible to the
operator at all time.
2. The location selected should not be exposed to high levels of electric
noise. Mounting the receiver next to an unshielded variable frequency
drive may cause radio interference. Always locate the receiver as far
away from variable frequency drives and electric motors as possible.
3. Ensure the selected location has adequate space to accommodate the
receiver. If an external antenna is used, to avoid the possibility of
antenna damage, always locate the receiver where the antenna is free
from any obstacles.
4. When installing an external antenna make sure the MCX jack located
on the RF/decoder board inside the receiver is connected and jumper
set to “EXT” position.
5. For better reception, make sure the receiver is in an upright position.
6. Drill four holes for mounting bracket type 1 and two holes for mounting bracket type 2 on the
control panel, wall, or location where the receiver is to be installed.
7. Make sure the screws, bolts, or shock absorbers are tightened after installation (not provided with
the system).
Mounting Bracket Type 1
Mounting Bracket Type 2
8. Slide down the receiver along the guided track to secure the receiver to the mounting bracket.
9. Remove the receiver by pressing down the bracket release and pull the receiver upward until
it clears the guided track.
