Flex 4Base® CE Instruction Manual
January 2017
Page 17 of 41
4.1.3 Remote Pairing
4.1.3.1 Transmitter-to-Transmitter Pairing
1. Obtain the original transmitter.
2. Press down the STOP button (transmitter power off).
3. Press and hold PB1 and PB3 at the same time.
4. Reset the STOP button by rotating it clockwise or counter-clockwise; it will pop up
(transmitter power on) – after a brief pause, let go of PB1 and PB3.
5. Repeat steps 2 through 4 for the new transmitter.
6. Now both the original transmitter and the new transmitter are in Remote Pairing Mode.
7. Simultaneously press and hold PB2 on the original transmitter (Status LED off and LED-B
constant red) and PB1 on the new transmitter (Status LED blinks green and LED-A
constant red).
8. When the Status LED (receiving data end) turns to constant green while both
pushbuttons are still pressed down, the pairing is completed.
9. Exit Remote Pairing mode by pressing down the STOP button on both transmitters.
NOTE: During remote pairing, make sure the distance between the two transmitters is within
1 meter.
