Flex 8EX / 12EX EU System Instruction Manual
March 2018
Page 25 of 66
4.1.2
Continuous Transmitting Time Adjustment
4.1.3
Pushbutton Functions with LED Displays
4.1.3.1 Standard Pushbutton Configuration (Transmitter Toggle)
Set transmitter toggle (latching output relay) function by adjusting the 8-position
function dipswitch located on the backside of the transmitter encoder board (
see Fig.
13
). LED 1 through LED 4 shown inside the shaded boxes in the table below illustrate
which LED on the transmitter will illuminate when the designated pushbutton is pressed
(PB5 - PB8 for 8EX; PB7 - PB12 for 12EX).
Fig. 13
After the pushbutton is released, the transmitter will
continue to transmit neutral signals to the receiver for up
to 1 minute. After 1 minute the transmitter will cease
transmission, thus temporarily disconnecting the receiver
MAIN.
After the pushbutton is released, the transmitter will
continue to transmit neutral signals to the receiver
depending on the time set in the I-CHIP. The default time
is 3 minutes. After that time the transmitter will cease
transmission, thus temporarily disconnecting the receiver
MAIN. Please contact your local dealer if your application
requires transmitting on time other than the default value
above.
(Type 1)
7
1
4
2 3
5 6
8
(Type 2)
7
1
4
2 3
5 6
8
5
2
1
3 4
8
6 7
FUNCTION
LED 1
LED 2
LED 3
LED 4
