6/2/2010
Page 19 of 25
Electrobar 8-Bar Instruction Manual
005-1044-R8
Chapter 11.0: Collectors
11.1: Mount the collector mounting post so the horizontal centerline of the post is 7” ± 0.75” from the
running surface of the conductor bar.
11.1.(a):
Slide each of the collectors onto the mounting post until they are directly under the
conductor bar it is going to run in.
Note: When mounting tandem collectors, be sure each collector shoe is positioned in the
appropriate conductor bar.
11.1.(b):
Tighten each bolt (upper and lower) until the collector is firmly in place (10 lb-ft).
11.1.(c):
Termination of collector leads should be in accordance with NEC and local electrical
standards.
Note: Before performing any maintenance on the system, be sure that the power to the system
has been disconnected following lock-out tag-out procedures.
7” ± 0.75”
C/L of Mounting Post
To Surface of
Conductor Bar
