LY72 Initial Setup Manual
6/14
Enter the settings confirmed in "Preparations before making initial settings (1/3)".
Repeat steps (1), (2), and (3) to make the basic settings.
MASTER
Master calibration
COUNTRY
(Destination)
SIG RES
(Measuring unit resolution)
Do not use the
master calibration
Use the master
calibration
STANDARD
(General area)
U.S.A.
JAPAN
0.5μm
0.1μm
10μm
5μm
1μm
10 minutes
1 minute
10 seconds
1 second
B
a
si
c
S
e
tt
in
gs
Step 2
SIG IN
(Input axis)
How to view
extended settings:
For extended settings,
press SART-key
when the input
resolution of each axis
is displayed.
2μm
100μm
50μm
25μm
20μm
0.05μm
1 degree
Axis LABEL
Switch with key
key to confirm the axis label
ABC or XYZ
default
default
default
default
default
Use the 1st to 3rd axes
Use the 1st axis only
Use the 1st and 2
nd
axes
Cannot be set when XYZ
label is selected
How to set up Basic Settings (2/3)
(1) Use key to change the basic setting item.
(2) The setting selection can be switched with key on the right side of the counter display.
(3) To define the new value, press key.
Operation:
- The current setting is displayed after about
one second. If there is no change in the setting,
the next item is displayed with key.
- The ABS lamp blinks while the parameter is
selected with the axis selection key..