Magnescale LY71, Instruction Manual

Page: 23 / 44

LY71
(E)
i
Contents
1. Basic Operation .............................................................. 1-1
1-1. Enabling Display .......................................................................................... 1-1
1-2. Setting the Display Value to Zero (Reset Function) ..................................... 1-1
1-3. Changing the Display Resolution ................................................................. 1-1
1-4. Reading the Maximum/Minimum Values of Measured Data ....................... 1-2
1-5. Recalculating the Maximum and Minimum Values (Restart Function) ....... 1-2
1-6. Switching the Display Data (Example: Maximum value
→
Peak-to-peak
Value) ........................................................................................................... 1-3
1-7. Setting Values to the Display (Preset Function) ........................................... 1-3
2. Applied Operation .......................................................... 2-1
2-1. Inch/mm Selector ......................................................................................... 2-1
2-2. Determining the Measurement Datum Point Position
(Datum Point Setting) .................................................................................. 2-1
2-3. Switching between the ABS Display and INC Display ............................... 2-2
2-4. Relocating the Datum Point Position (Reference Point Operation) ............. 2-2
2-4-1. Recording the datum point position ............................................ 2-2
2-4-2. Relocation of the datum point position ....................................... 2-3
2-5. Pausing Maximum Value/Minimum Value Calculation (Pause) .................. 2-3
2-6. Pausing Updates of Display Data (Latch) .................................................... 2-4
2-7. Changing the Display Scale ......................................................................... 2-4
2-8. Reducing Flickering of the Minimum Digit ................................................. 2-4
2-9. Disabling Key Operation (Preventing Accidental Operation) ...................... 2-4
2-10. Power Outage Detection On/Off .................................................................. 2-5
2-11. Power Save ................................................................................................... 2-5
2-12. Using Measuring Units with Two Axes for Measurement ........................... 2-5
2-13. Operation for each Axis ............................................................................... 2-6
2-14. Changing the Display Axis ........................................................................... 2-6
2-15. Master Calibration ........................................................................................ 2-7
2-16. External Input/Output ................................................................................... 2-8
2-16-1. Outputting a signal when going past the zero point .................. 2-8
2-16-2. Resetting with an external signal ............................................... 2-8
2-16-3. Switching the display data from an external device .................. 2-8
2-16-4. Sending alarm signals to an external device .............................. 2-8
2-16-5. Sending the display mode to an external device ........................ 2-9
2-16-6. Relocating the datum point position with an external signal .... 2-9
2-16-7. Sending the reference point detected signal to an external
device ......................................................................................... 2-9
2-16-8. Operating the hold function from an external device ................ 2-9
2-16-9. Operating restart from an external device ............................... 2-10
2-16-10. Setting a value input by Preset from an external device .......... 2-10
2-17. Clearing the Display ................................................................... 2-10
2-18. Presetting Multiple Points .......................................................................... 2-10
2-19. Compensating the Position ......................................................................... 2-11
2-19-1. Compensation ............................................................................ 2-11
2-19-2. Linear Compensation ................................................................ 2-11
2-20. Outputting Data to BCD ............................................................................. 2-14
2-21. Using the Comparator ................................................................................ 2-14