1/5
LH71/LH72 Tool offset function Operating manual
Contents
Page
1. First of all
1
2. Target model
2
3. Front panel
2
4. Positional relationship between TOOL master (reference) and other TOOLs (conceptual diagram)
2
5. Settings
and operations
Change tool master number
3
Tool master coordinate setting (for scale with reference point)
3
Tool master coordinate setting (for scale with reference point)
4
Setting the number and offset value of the tool to be used
5
Ver. 3 (2021.1)
CS&S
LH71/72
LH72
Tool offset function
Operation manual
1. First of all
OPERATION FLOW
The tool offset function is used in absolute mode (ABS). You must set up a tool master to use this function. The
coordinate position of each tool is a coordinate value managed by the offset amount with respect to the tool master.
Therefore, if you change the value of the tool master, the coordinates of other tools will change automatically.
The tool master is set to number 1 in the factory settings, but in this operation manual, the tool master is set to a tool
number that is not normally used. Then, in the actual operation, we will explain how to set and operate only the tools
that are normally used without using the tool master.
NOTE: Set the X-axis display setting to diameter display (Φ lamp lights up).
Change tool
master number
Tool master
coordinate settings
Setting the number
and offset value
START
Finished
STEP
１
STEP 2
STEP 3
Table of contents
STEP
１
STEP 2-1
STEP 3
STEP 2-2
