Magnavox MX2000, Owner'S Manual, Page: 2 / 30

Voice Dialer Instructions
To Set Up Auto Dial:
1. Program Phone Numbers
To have your Central Controller call a friend/neighbor/relative when a break-m occurs, follow the
steps below to program in up to four telephone numbers.DO NOT program in your local police department
or 9 11; many States and Localities will not allow a recorded message to be sent to the police or 9 11.
STIFF
FINES AND PENALTIES MAY RESULT.
A Slide the Slider Switch to SEC.
B. Press TEL CODE, then number button 3. Controller beeps.
C. Use the number keypad to enter the phone You may select a number of any length.
D. Press the ENTER button
E. Use the number keypad to enter the memory number of the phone number: or 4. The Central
Controller will beep twice.
F. Repeat steps A-E for the other three phone numbers.
2.
Record a Message
A With the Slider Switch in INSTALL SEC position, press the RECORD button. The RECORD light on
the display panel will appear.
B. Speak into the microphone for up to fifteen seconds. A message similar to this one is suggested:
“Hello. This is the Johnson’s home security system. The Johnson’s home security system has been
breached_ Wait until this message stops, then press on your phone to listen in on the Johnson
household
you
hear anything unusual, please call the police.”
C. When you are finished, wait until the RECORD light disappears.
3. Review Your
Message
A Attach the supplied earphone to the back of the unit.
B. Place the earphone earpiece in your ear.
C. Slide the Slider Switch to RUN 1 or RUN 2 position
D. Press the RECORD button The RECORD light will appear, and your message will be played back
through the attached earphone.
4.
Testing Your Home Security System Voice Dialer
To test de system, you should have installed all of the Door/Window Sensors, programmed
in up to four different phone numbers, recorded your personal message, and hooked up several lamps to the
Lamp Units. All completed? Good! We’re ready to test the system.
Note: If you selected the friends/neighbors setting earlier in the setup, let the person who will be receiving
your recorded message know you are testing your system and they will be receiving your distress message.
A
B.
C.
.
.
.
Make sure the Central Controller’s Slider Switch is in either the RUN 1 or RUN 2 position.
Press ARM HOME. The controller will beep once and the ARM LIGHT will turn on the system
does not beep, refer to the “Arming and Disarming” section of your manual).
Open a monitored door or window.
The Siren will sound
All lights connected to Lamp Units will flash.
After 30 seconds, the system will seize your phone line and automatically call your designated friends/
neighbors.
D. Disarm your system.
l
Enter your 3digit PIN.
l
Press the DISARM button.
SMARTHOME.COM™
1-800-SMART-HOME
949-221-9200
http://www.smarthome.com
Order #7308KIT