Magnavox CT202MW8, Service Manual, Page: 18 / 89

1-6-2 P7752DC
Reference Notes in the Table
CAUTION!
When removing the CRT, be sure to discharge the
Anode Lead of the CRT with the CRT Ground Wire
before removing the Anode Cap.
1. CAUTION 1: Discharge the Anode Lead of the
CRT with the CRT Ground Wire before removing
the Anode Cap.
Disconnect the following: Anode Cap, CN2501,
CRT CBA, CN1601, CN2571, CN3801 and
CN3802. Then remove Tray Chassis Unit.
2. CAUTION 2: Electrostatic breakdown of the laser
diode in the optical system block may occur as a
potential difference caused by electrostatic charge
accumulated on cloth, human body etc., during
unpacking or repair work.
To avoid damage of pickup follow the next
procedures.
1) Disconnect Connector (CN301) on the DVD
Main CBA Unit.
2) Short the three short lands of the FPC cable
with solder before removing the FFC cable
(CN201). If you disconnect the FFC cable
(CN201) without shorting them, the laser diode
of pickup will be destroyed. (Fig. D4)
3) Remove DVD Mechanism.
3. CAUTION 3: When reassembling, confirm the
FFC cable (CN201) is connected completely. Then
remove the solder from the three short lands of the
FPC cable. (Fig. D4)
4. Remove screws 3(S-8) and remove Top Shield.
Remove screws 7(S-9), (S-10) and (S-11). Then,
desolder connectors (CL1201, CL1401, CL1402,
CL1403) and lift up the Deck Assembly.
[1] Rear Cabinet
(S-1)
(S-1)
(S-1)
Fig. D1
(S-3A)
(S-2)
(S-3B)
(S-1)