1-8-2
TD603DC
Reference Notes in the Table
Caution !
When removing the CRT, be sure to discharge the
Anode Lead of the CRT with the CRT Ground Wire
before removing the Anode Cap.
Reference Notes in the Table
CAUTION 1: Discharge the Anode Lead of the CRT
with the CRT Ground Wire before removing the Anode
Cap.
1. Disconnect the following: Anode Cap, CN501, CRT
CBA, CN571, CN2602, CN1301 and CN1302.
Then remove H.V. CBA (with Holder).
CAUTION 2: Electrostatic breakdown of the laser
diode in the optical system block may occur as a
potential difference caused by electrostatic charge
accumulated on cloth, human body etc., during
unpacking or repair work.
To avoid damage of pickup follow next procedures.
2-1. Slide the pickup unit as shown in Fig. 5.
2-2. Short either of the two type three short lands with
solder before removing the FFC cable (CN101)
from it. If you disconnect the FFC cable (CN101),
the laser diode of pickup will be destroyed. (Fig.
5)
2-3. Disconnect Connector (CN401). Remove screws
3(S-7) and lift the DVD Main CBA Unit. (Fig. 5)
CAUTION 3: When reassembling, confirm the FFC
cable (CN101) is connected completely. Then remove
the solder from the three short lands. (Fig. 5)
4. Remove screws 7(S-10) and 2(S-11). Then, desol-
der connectors (CL1201, CL1401, CL1402,
CL1403) and lift up the Deck Assembly.
