© 2016 Magnaflux
Page 3
Magnaflux-SRVC-TS032
Issued: Mar 2016
Rev. 1
Replacement Procedures
Prior to starting any repairs — the EV6000 should be disconnected from
the power supply.
A. Replacement of Rear Cover Gasket
1. Using the 3 mm hex key wrench, loosen and remove the 4 shoulder bolts that hold on
rear cover shown in Figure 1.
2. Once the 4 shoulder bolts are removed, carefully lift the rear cover off of the EV-6000.
The rear cover gasket may or may not come off with the rear cover.
3. In order to replace the rear cover gasket, you will have to remove the electrical part of
the “On/Off” switch called the micro-switch This is easy to do — but it is also easy to
break the switch. Refer to Figure 2 on the following page and follow the instructions to re-
move the operational part of the “On/Off” switch.
Figure 1
Shoulder Bolts
Shoulder Bolts
