Magmaweld RS 350 MK, User Manual

Page: 21 / 68

21
www.magmaweld.com USER MANUAL | KULLANIM KILAVUZU
RS 350 MK PRO
EN
3.4 Selection and Replacement of Wire Feed Rollers
• Open the cover of the wire feed part. You will see the four-roller wire feed system.
1-
Engine
2-
Euro Connector
3-
Pressure Roller Handle
4-
Pressure Rollers
5-
Wire Feed Rollers
6-
WF Roller Screws
Figure 10 : Wire Feed System
1
2
3
4
4
5
5
6
6
• Use wire feed rollers suitable for the material and diameter of
the welding wire you will use. Use V-grooved wire feed rollers for
steel and stainless steel, corrugated V-grooves for cored wires
and U corrugated ones for aluminum.
• If you need to replace the wire feed rollers, pull the pressure
roller lever toward your side and after lifting the pressure rollers,
remove the wire feed roller screws and remove the existing
rollers.
Figure 11 : Wire Feed Roller Removal
Both sides of the rollers are marked according to the wire diameter used. Place the rollers
on the flange so that the wire diameter value you will use will be on the side facing your
side.
• After inserting the rollers, you will use, re-insert the screws and
lower the pressure rollers and lock the pressure roller lever onto
the rollers.
Figure 12 : Wire Feed Roller Placement
0.8 mm
Operation