20
www.magmaweld.com
USER MANUAL | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
EN
monoTIG 160i / monoTIG 200i
Push the torch trigger and do not release your finger. Current starts with start current after pre gas-flow period
and increases according to the up-slope time adjustment and reaches to value of the main current. Welding goes
on with the main current as long as the torch trigger is kept pushed. After releasing the trigger, current decreases
according to down-slope time adjustment and reaches to final current, after post gas-flow period the operation
ends.
When torch trigger is pushed, following the pre-gas flow, initial current starts and when the trigger is released the
currrent ramp leads to the welding current. If DC PULSE mode is selected, according to the adjusted
frequency, welding current oscillates between this reached welding current and the base current. If the trigger
will be pushed and released more than 1 second, current decreases according to down-ramp adjustment, reaches
to the final current, after post gas, welding ends.
Base current is generally used for repairing and cooling during welding and crater filling at the finishing of the
welding beads. Either during DC or during Pulsed DC welding if the trigger is pushed and released less than 1
second, DC base current will be on.
If the trigger will be pushed less than 1 second, welder will go back to the existing welding mode and parameters,
but if the trigger will be pushed and released more than 1 second, welding will be finished by following the
down-ramp, final current and post-gas.
3.3.2 Usage of the TIG Welding Trigger
2 Stroke TIG Trigger
4 Stroke TIG Trigger
PrG :
Initial Gas Time
I :
Welding Current
PoG :
Final Gas Time
When the torch trigger is pushed, main current starts immediately and goes on as long as the torch trigger is kept
pushed. Welding goes on during spot welding time. After spot welding time is over, current stops immediately.
Spot TIG Trigger
PrG :
Initial Gas Time
I :
Welding Current
PoG :
Final Gas Time
Push the welding mode selection button. For selecting the MMA welding mode. Stick electrode welding LED lights.
Adjust the current via current adjustment knob. Below table can be used as a rough referance for mild steel
electrodes. For exact parameters, please refer to the electrode manufacturer recommendations.
3.3.3 MMA Welding Process
Operation