Monostick 180i
EN
www.magmaweld.com
4
USER MANUAL | MANUAL DO UTILIZADOR | KULLANIM KILAVUZU
Safety Precautions
SAFETY PRECAUTIONS
Be Sure To Follow All Safety Rules In This Manual!
Make certain that the installation procedures comply with national electrical standards and
other relevant regulations, and ensure that the machine is installed by authorized persons.
• Safety symbols found in the manual are used to identify potential hazards.
• When any one of the safety symbols are seen in this manual, it must be understood that there is a risk
of injury and the following instructions should be read carefully to avoid potential hazards.
• The possessor of the machine is responsible for preventing unauthorized persons from accessing the
equipment.
• Persons using the machine must be experienced or fully trained in welding; they have to read the
user manual before operation and follow the safety instructions.
• Read the user manual, the label on the machine and the safety instructions carefully.
• Make sure that the warning labels on the machine are in good condition. Replace missing and
damaged labels.
• Learn how to operate the machine, how to make the checks in a correct manner.
• Use your machine in suitable working environments.
• Improper changes made in your machine will negatively affect the safe operation and its longevity.
• The manufacturer is not responsible for the consequences resulting from the operation of the device
beyond the specified conditions.
• Wear dry and sturdy insulated gloves and working apron. Never use wet or damaged gloves and wor
king aprons.
• Do not touch the electrode with the bare hand.
• Never touch parts that carry electricity.
• Never touch the electrode if you are in contact with the electrode attached to the work surface, floor
or another machine.
• By isolating yourself from the work surface and the floor, you can protect yourself from possible
electric shocks. Use a non-flammable, electrically insulating, dry and undamaged insulation material
that is large enough to cut off the operator’s contact with the work surface.
• Do not connect more than one electrode to the electrode holder. Keep the machine turned off when
not in use.
• Before repairing the machine, remove all power connections and/or connector plugs or turn off the
machine.
• Be careful when using a long mains cable.
• Check all cables frequently for possible damage. If a damaged or an uninsulated cable is detected,
repair or replace it immediately.
• Make sure that the grounding of the power line is properly connected.
ATTENTION
Indicates a potentially hazardous situation that could cause injury or damage. In case if no precaution is
taken, it may cause injuries or material losses / damages.
IMPORTANT
Specifies notifications and alerts on how to operate the machine.
DANGER
Indicates a serious danger. In case if not avoided, severe or fatal injuries may occur.
Explanation Of Safety
Information
Comprehending Safety
Precautions
Electric Shocks
May Kill
Definition Of Safety
Symbols
