Magmaweld ID 65 PX, User Manual

Page: 25 / 248

EN
25
www.magmaweld.com USER MANUAL
ID 65 PX / ID 65 P
Pressure Indicator
It shows the pressure inside the torch.
Adjustment Pot
: Current Adjustment / Gas Adjustment
To adjust the current, the adjustment pot is turned left or right to set the current value
to certain tolerance ranges.
Press the adjustment pot once to switch to gas adjustment. The machine switches
to free gas mode, the pressure display shows about 4.2 bar. When you pull the
gas pressure adjustment pot on the air filter to the top and set it to the free position,
you can increase / decrease the pressure by turning it to the right / left.
3.2 Torch Usage
Press the torch trigger by pushing the protective cap on the torch trigger forward when cutting process
is to be started. Plasma arc will occur as soon as you press the torch trigger. The torch tip must be pushed
forward slowly through the material to be cut in order to ensure smooth cutting. When the automation torch is
connected, the machine detects the automation torch and waits for a trigger from the automation interface. It
sends the necessary data to the automation interface. See 5.1 for detailed information on torches.
The torch trigger is active when the power supply is on. Make sure that your hand is not in the
way of the cutting path.
Do not hold the work piece in your hand or point the torch to yourself or anyone else.
Operation