EN
www.magmaweld.com
15
ID 500 M/MW PULSE
USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
2.3 Connections
For your safety, never use the mains cord of the machine without a plug.
2.3.1 Mains Plug Connection
2.3.2 Connecting the Grounding Clamp to the Workpiece
• No plug has been connected to the mains cable since there may different types of
outlets available in plants, construction sites and workshops. A suitable plug
must be connected by a qualified technican. Make sure that the grounding cable
marked with and a yellow/green color is present.
• AFTER CONNECTING THE PLUG TO THE CABLE, DO NOT ATTACH IT TO THE OUTLET AT
THIS STAGE.
• Firmly connect the grounding clamp to the workpiece as close as possible to the welding area.
Figure 3: Power Plug Connection
Figure 4: Gas Cylinder - Heater - Regulator Connections
2.3.3 Connecting the Gas Cylinder
• Use regulators and heaters that comply with international standards to work safely and achieve the best results. Make sure the size of the hose
connection of the gas regulator you are using is 3/8” (9.5mm).
• Open the gas cylinder valve
(22)
, keeping your head and face away from the outlet of the valve and keep it open for 5 seconds. By this means,
possible sediment and impurities will be discharged.
• If the CO2 heater is to be used, first connect the CO2 heater
(27)
to the gas cylinder
(21)
. After connecting the gas regulator
(20)
to the CO2 heater
(27)
, insert the plug of the CO2 heater
(28)
into the CO2 heater outlet on the back of the machine.
• If the CO2 heater will not be used, connect the gas regulator
(20)
directly to the gas cylinder
(21)
.
19-
Chain
24-
Gas Hose
20-
Gas Regulator
25-
Flowmeter
21-
Gas Cylinder
26-
Manometer
22-
Gas Cylinder Valve
27-
CO2 Heater
23-
Flow Adjustment Valve
28-
CO2 Heater Energy Cable
Installation
