EN
32
www.magmaweld.com
USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
ID 400 MK PULSE EXPERT / ID 400 MKW PULSE EXPERT
3.6 Connection to Mains
Depending on the selected mode, welding set current
adjustment will be done with the help of the pot. The
setting will be performed by turning the pot left or
right.
Connect the poles according to the
type of the welding process.
• Start the machine with the on/off switch.
• Turn the machine off by turning the on / off switch back to off after hearing the fan noise and seeing the
mains lamp is illuminated.
3.7 Selection and Replacement of Wire Feed Rollers
• When you open the cover of the wire feeding section, you can adjust the free gas and wire with the button
on the side. You will see the four-roller wire feeding system with an encoder structure. Thanks to its 4 WD
system structure, the wire is mechanically driven with the power applied to the four rollers. Even in
negativities such as motor heating and increased friction, the wire feed speed will not change, provides
excelent arc stability. As soon as the machine is energized, the LED inside of the compartment will be active
which will make it easier to replace the roller.
• Use wire feed rollers suitable for the material and diameter of the welding wire you will use. Use V-grooved
wire feed rollers for steel and stainless steel, V-grooves type for cored wires and U-grooves type for
aluminum.
• If you need to replace the wire feed rollers, pull the pressure adjustment screw toward your side
(1)
and
after lifting the roller covers
(2)
, remove the existing rollers
(3)
(Figure 9).
Figure 8 : Wire Feed System
1-
Motor
2-
Euro Connector
3-
Pressure Adjustment Screw
4-
Top Wire Feed Rollers
5-
Bottom Wire Feed Reels
6-
Wire Feed Rollers Locking Mechanism
1
2
3
3
4
4
5
6
• You must unlock the rollers before you can remove them. By reverse-turning the
locking direction, the cavities inside the wire feed roller must be overlapped with the
protrusions on the wire feed body in order to unlock the lock.
• Both sides of the rollers are marked according to the wire diameter used.
• Place the rollers on the flange so that the wire diameter value you will use will be on the
side facing your side.
Operation
Summary of Contents for ID 400 MK PULSE EXPERT
Page 177: ......
