Magmaweld ID 350E, User Manual

Page: 15 / 96

15 ID 350E
EN
www.magmaweld.com USER MANUAL
2.6 TIG Welding Connections
• According to the polarity of the electrode to be used, insert
welding cables into the appropriate outlet and tighten them by
turning clockwise.
• Connect the earth clamp tightly to the workpiece as close as
possible to the welding area.
• TIG torch with a valve should be used.
• Connect the TIG torch power cable to the negative outlet and the
earth cable to the positive outlet of the machine.
• Install the Argon gas regulator onto the Argon gas cylinder.
• Connect the gas hose of the torch to the gas regulator.
Figure 3 : MMA Welding Connections
Figure 5 : TIG Welding Connections
Figure 4 : Connecting Gas Cylinder
2.3 Mains Plug Connection
2.5 Connections for MMA Welding
For your safety, never use the mains cord of the machine without a plug.
• No plug has been connected to the mains cable since there may different types of outlets available in plants,
construction sites and workshops. A suitable plug must be connected by a qualified technican. Make sure that
the grounding cable marked with and a yellow / green color is present.
• After connecting the plug to the cable, do not attach it to the outlet at this stage.
Installation
• Check the 3-phase with a voltmeter before connecting the machine to
the mains. After detecting that each phase is 400V (± 40V), attach the
plug into the wall outlet.
• Start the machine with the on / off switch.
• Turn the machine off by turning the switch back to the “0” position
after hearing the fan sound and seeing the ammeter and voltmeter
lights are on.
Figure 2 : Mains Connection
2.4 Connection to Mains
When plugging the power plug into the outlet, make sure that the power switch is set to “0”.