Magmaweld EXPERT Series, User Manual

Page: 33 / 228

33
www.magmaweld.com USER MANUAL
EXPERT SERIES
EN
3.6 Connection to Mains
Figure 7 : Wire Feed Roller Placement
• Place the roller to be used so that the cavities inside the wire feed roller overlap the protrusions on the wire
feed body. Turn to the right or left to ensure that the locking sound is heard and that the wire feed rollers are
in place. Then lower the pressure rollers and lift the pressure roll lever to lock it onto the pressure roller.
• Start the machine with the on/off switch.
• Turn the machine off by turning the on / off switch back to off after hearing the fan noise and seeing the mains
lamp is illuminated.
3.7 Selection and Replacement of Wire Feed Rollers
• When you open the cover of the wire feeding section, you can adjust the free gas and wire with the button on
the side. You will see the four-roller wire feeding system with an encoder structure. Thanks to its 4 WD
system structure, the wire is mechanically driven with the power applied to the four rollers. Even in
negativities such as motor heating and increased friction, the wire feed speed will not change, provides
excelent arc stability. As soon as the machine is energized, the led inside of the compartment will be active
which will make it easier to replace the roller.
• Use wire feed rollers suitable for the material and diameter of the welding wire you will use. Use
V-grooved wire feed rollers for steel and stainless steel, V-grooves type for cored wires and U-grooves
type for aluminum.
• If you need to replace the wire feed rollers, pull the pressure adjustment screw toward your side and after
lifting the roller covers, remove the existing rollers.
Figure 5 : Wire Feed System
a-
Motor
b-
Euro Connector
c-
Pressure Adjustment Screw
d-
Top Wire Feed Rollers
e-
Bottom Wire Feed Reels
f-
Wire Feed Rollers Locking Mechanism
• You must unlock the rollers before you can remove them. By reverse-turning the
locking direction, the cavities inside the wire feed roller must be overlapped with the
protrusions on the wire feed body in order to unlock the lock.
• Both sides of the rollers are marked according to the wire diameter used.
• Place the rollers on the flange so that the wire diameter value you will use will be on
the side facing your side.
Depending on the selected Mode, welding set current
adjustment will be done with the help of the pot. The setting
will be performed by turning the pot left or right.
Connect the poles according to
the type of the welding process.
Figure 6 : Wire Feed Roller Removal
(1)
(6)
(3)
(4)
(3) (4)
a
b
d
e
f
d
c
c
Operation
(2) (5)