Magmaweld EXPERT Series, User Manual

Page: 32 / 228

32
www.magmaweld.com USER MANUAL
EXPERT SERIES
EN
3.4 Arc Length Adjustment (ArC)
When you press and hold the adjustment knob for 3 seconds, the arc length function will be active. The factory
setting is 0.0. You can change the arc length adjustment in the range of + 7 / -7 by turning the same knob to the
right or left. As it goes t7, the wire approaches the nozzle, the arc length increases. As it goes towards
-7, the wire approaches the welding metal and the arc length decreases. After the desired setting is made, the
setting is exited by pressing the same knob.
3.5 MIG Curve
Operation
Set Wire
Wire 0 - 25
Spot
Set Voltage
Voltage 0 - 25
Crater Open
Pre Gas
Crater Closed
Pre-Gas
Pnt Mode
On
Pnt Mode
Off
Post Gas
Pre-Gas
Crater
Crater
Burn Back
Burn Back
Burn Back
Post Gas
Post Gas
Post Gas
Burn Back
Post Gas
Set Voltage
Voltage 0 - 25
Crater Open
Pre Gas
Set Wire
Wire 0 - 25
Crater Closed
Pre-Gas
Slow Release
Off
Slow Release
On
Slow Release
On
Slow Release
Off
Value Range
Factory Setting
2- Position MIG
0,0 - 9,9 sec 0,1 sec
0,0 - 9,9 sec 0,0 sec
Method / 2 / 4 / 6
2
25 - 0 - 25 0 step
Thickness
Wire Type
Trigger
Cooling Time
0,6 - 20,0 mm 1,0 mm
Arc On Time
Arc Off Time
0,0 - 9,9 sec 0,1 sec
Clicking Adjustment
Wire Diameter 0,8 - 1,6 mm 1,0 mm
MIG / MAG - MMA
1 - 5 min
MIG / MAG
1
0,2 - 9,9 sec 0,2 sec
SG/FE, Flux Rutil, Flux Basic, AIMg 4,5Mn, AIMg5, AIsi 5, AL 99,5
4- Position MIG 6- Position MIG
82/18, 92/8, %100 Ar, %100 CO 2 , %97,5/2,5
Synergic / Smart / Classic / Cell-Gauging / Ruile-Basic / Method
Active / Passive
Active / Passive
Passive
Passive
Method
Pre-Gas
Burn Back
Post Gas
Gas Type
Crater
Mode